IFB washing machine error codes
Independent repair, not IFB's service centre.
IFB washing machines show short words, not only numbers. tAP means water is not coming in. On top loads, drEr means water did not drain. unbL means the load is uneven. On front loads, dLEr means the door is stuck. Codes differ by model, so check your manual too. The table below lists more.
- Visit charge ₹199, taken off your bill if you repair.
- Same-day visit when you book during our hours (9 AM to 9 PM).
- 100 days warranty on the parts we replace.
Not sure what is wrong? Tell us what you see or hear.
See all parts
Control boardError codes, not starting
You notice: Error codes, not starting. Check first: Switch it off at the wall for two minutes, then on again. If the same code comes back, note it and tell us.
Book this repairInlet valveNot filling
You notice: Not filling. Check first: Check the tap is fully open and the inlet hose is not bent or blocked.
Book this repairDoor gasketLeaking water
You notice: Leaking water. Check first: Look inside the rubber fold for coins, hair or a tear.
Book this repairDrum bearingsNoise, shaking
You notice: Noise, shaking. Check first: Run it empty. If the rumble stays, stop using it so the drum is not damaged.
Book this repairMotor and beltDrum not spinning
You notice: Drum not spinning. Check first: Make sure the load is not too heavy. Overloading wears out belts and bearings.
Book this repairDrain pumpNot draining
You notice: Not draining. Check first: Unplug it, then open the small filter door at the bottom front and clean the filter. Keep a towel ready.
Book this repair
Front-load washing machine, cutaway
Safety first
Switch off at the socket with dry hands, then unplug. Is the socket wet, warm, sparking or smelling of burning? Do not touch it. Call us.
Burning smell, sparks, or water near a socket? Do not touch the appliance or the plug. Keep everyone away. Call us.
Fire, or smoke filling the room? Leave the house. Call 112.
IFB codes and what they mean
| Code | What it means | Check first | When to call us |
|---|---|---|---|
| tAP | Water is not coming in. | Turn the tap fully on. IFB says the machine restarts when water comes. | tAP stays with good water flow. |
| drEr | Top load: the water did not drain in time. | Check the drain hose end is not sitting in water. | Water stays in the tub. |
| door | Front load: the door is not closed or locked. | Open the door, then close it properly. | door stays after that. |
| dor | Top load: the lid is open. | Close the lid. It will not run with the lid open. | It shows with the lid shut. |
| dLEr | Front load: the door is stuck or jammed. | Switch off. Wait 2 minutes. Do not force the door. | The door still will not open. |
| E1 | Front load: clothes trapped between the drum and the door. | Switch off, wait 2 minutes, run Drain. Then rearrange the clothes. | E1 comes back. |
| E2 | Front load: IFB gives the same steps as for E1. | The same steps as E1. | E2 comes back. |
| unbL | The load is unbalanced. | Add 1 or 2 similar items. Spread the load out. | unbL stays with an even load. |
| HEAt | Front load: the water is too hot at the start. | Hot water inside. Do not open the door. Let it cool. Then start a new program or Drain. | HEAt comes back. |
| LSE | Top load: a load sensing error. | Switch off with the Power button. Switch on and try again. | LSE comes back often. |
| CPE | Top load: IFB says the motor capacitor may be faulty. Overloading can also cause it. | The capacitor is a small part that helps the motor start. Do not run it again. | Book a visit. |
| ACH | Top load: the mains voltage is too high. | IFB says it restarts when the voltage is safe. | Stop using it. Book a visit. |
| ACL | Top load: the mains voltage is too low. | IFB says it restarts when the voltage is safe. | Stop using it. Book a visit. |
| dLAY | Front load: a delayed start is set. Not a fault. | Wait, or cancel the delay. | No need to call. |
Front loads and top loads use different words. A front load shows door. A top load shows dor.
For tAP, IFB's guide says to clean the hose mesh filter. That means taking the hose off. Leave that to us.
Still happening? Stop. Book a visit.
What it can cost
Price
Visit charge ₹199. If you repair, it is taken off your bill. If you say no, you pay only the visit charge.
Price confirmed after inspection.
We tell you the repair price first. No repair starts until you say yes.
Check IFB's manual
Find your model on IFB's product help page. It lists the codes for that model.
Questions
What does tAP mean on an IFB washing machine?
IFB says tAP means water is not coming in. The tap may be off, or the supply is weak. Turn the tap fully on first.
What does dLEr mean on an IFB front load?
IFB says the door is stuck or jammed. Switch off and wait 2 minutes. Do not force the door.
Why does my IFB show unbL?
The load is uneven in the drum. IFB says small loads can cause it, like one pair of jeans. Add 1 or 2 similar items.
My IFB door will not open. Can I force it?
No. Switch off at the socket with dry hands, then unplug. Is the socket wet, warm, sparking or smelling of burning? Do not touch it. Call us. Wait, then try once more. Still happening? Stop. Book a visit.
How much does it cost to fix an IFB error?
Visit charge ₹199, taken off your bill if you repair. You hear the repair price before any repair starts.